Baby Jogger CITY SELECT Manuel d'utilisateur télécharger pdf (Page 4)

Peg-Perego

Uses the 2 Adaptor Brackets, U-shaped bar (A),

U-shaped bar (B), and the Spring support bar (C)

1 Insert Adaptor Brackets into the

corresponding mounting brackets on your

stroller. The Adaptor Brackets are secure

when they click into place.

NOTE: The right and left mounting

brackets on your stroller are

determined by standing in front of

and facing the stroller.

3 Insert the U-shaped bar (A) into the openings on the front

of the adaptor brackets.

4 Close the compression locks on the adaptor

brackets by flipping the red latches down,

locking the U-shaped bar (A) in place.

Support Bar Configuration:

The car seat adaptor comes fully assembled for use with Graco model car seats. The Graco support bar (D) must be

removed prior to attaching your Peg-Perego car seat to the Baby Jogger Car Seat Adaptor.

1 Holding the U-shaped bar (B), unsnap Graco support bar (D)

from the Spring support bar (C) and remove.

Car Seat Adaptor Installation:

CLICK

2 Open the compression

locks on the Adaptor

Brackets by flipping

the red latches up.

6 Place car seat on the car seat adaptor and

press down firmly until it clicks into place.

Fasten and properly tighten the Adaptor

Bracket Safety Belt over the car seat before

operation.

Indicator

CLICK

5 From the rear of the stroller, connect the second U-shaped bar (B)

over the ends of the already installed U-shaped bar (A) until it

clicks into place. You will see only green in the indicator on top of

the bars when the U-shaped bars are locked in place.

1 2 3 4 5 6 7 8

Pas de commentaire

Baby Jogger CITY SELECT Manuel d'utilisateur Page 4